Philips Sound Solutions
3.3.3. Equalizer Tab
The Equalizer (EQ) controls the frequency response of the system by increasing or decreasing the frequency response of ten independent frequency bands.
This Equalizer works very much the same as the equalizers in high quality sound systems. Each slider controls the relative level of a band (range) of frequencies. The number listed above each slider column is the center frequency of the band controlled by that slider. When a slider is set to the center position, frequencies within this band left flat and the gain is 0dB. See Figure 13.
Figure 13
To boost the level of a given band, move its slider above the centerline. To cut the relative level of a given band, move its slider below the centerline. Maximum boost or cut is ±12dB on each direction.
Sliders can be individually centered by right clicking anywhere within the slider area, or collectively by clicking the Reset button on top right corner of the panel. Sliders can also be collectively centered by clicking the Default button on the compact panel. Please note that the default button resets several other features as well.
3.3.4. Setup Tab
This tab contains the controls to select and configure your speaker mode based on the type and number of speakers you have.
Your Dynamic Edge soundcard supports a wide range of speakers. From the list on the left side of the Setup tab, you can choose the desired output configuration. This sets up the nature of audio processing, spatial algorithms, and the number of outputs, to suit your choice. Following is a detail explanation of each output mode and each control on this tab. See Figure 14.
Dynamic Edge™ Soundcard User’s Guide | 21 |