Black Box AC506A manual Installation, Plug-and-Play

Page 7
2. Installation

AC506A

2. Installation

Figure 2.1

1.Plug in the desired number of VGA sources to the VGA inputs on the back of the AC506A.

2.Connect an output device to the VGA output on the back of the AC506A.

3.Connect the included RS-232 cable to a PC if so desired.

4.Connect the included power supply.

5.Power on the included power supply

Plug-and-Play

DDC (Direct Data Channel) is a standard by which a compatible monitor sends its identification and other parameters to a PnP operating system such as Windows XP etc. The AC506A does not switch the PNP signal lines to the PC. This means that, in some instances, you may have to select a new monitor or video settings on your PC. Also notice that most Notebook PC's have a special function key to activate the external video output connector

6

Image 7
Contents 877-877-BBOX 4x1 Compact VGA SwitchModel AC506A CUSTOMER SUPPORT INFORMATION4x1 Compact VGA Switch FEDERAL COMMUNICATIONS COMMISSIONRADIO FREQUENCY INTERFERENCE STATEMENT EUROPEAN UNION DECLARATION OF CONFORMITYINSTRUCCIONES DE SEGURIDAD Normas Oficiales Mexicanas NOM Electrical Safety StatementAC506A 18. Servicio por personal calificado deberá ser provisto cuando Contents q Infinite switching cycle life q Can drive long cables 1.2 Features1. Introduction 1.1 GeneralPlug-and-Play 2. Installation3.2 Front-Panel Switches 3. Configuration & Operation3.1 Modes of Operation 3.3 RS-232 control via Hyper Terminal 2. The PC does not recognize a Plug-and-Play monitor 4. Troubleshooting3. Substituting power supplies 1. Fuzzy, blurry, or ghosting imageContacting Black Box Shipping and PackagingTemperature 5. SpecificationsPower WeightAC506A Page 1000 Park Drive Copyright 2004. Black Box Corporation All rights reservedLawrence, PA