Samsung HT-SK6 To set up Speaker Balance, Speaker Setting Methods, Example 5.1CH Sound Setup

To set up Speaker Balance

To set up Speaker Balance

1

Press the Sound Edit button. Each time the button is pressed, the selection switches as shown below.

Sound Edit

2

Use the Left/Right ( ▲ / ▲) button to raise or lower the output level of the chosen speaker(s).

Example: 5.1CH Sound Setup

L C	R
LFE	D I G I T A L

LS S RS

OFF, range of – 6 ~ 0

Front Speakers: L level, R level

L C	R
LFE	D I G I T A L

LS S RS

OFF, range of – 6 ~ 0

Rear Speakers: L level, R level

L C	R
LFE	D I G I T A L

LS S RS

range of – 6 ~ – 00 ~ +6

Center Speaker

L C	R
LFE	D I G I T A L

LS S RS

range of – 6 ~ – 00 ~ +6

Rear Speakers

L C	R
LFE	D I G I T A L

LS S RS

range of – 6 ~ – 00 ~ +6

Subwoofer Speaker

The display changes depending on the current audio output mode (DSP, PRO LOGIC, 3-STEREO, STEREO, etc.).

Speaker Setting Methods Test Tone

Press the Test Tone button.

•The test signal will be sent to the Left Front ➞ Center ➞ Right Front ➞ Right Rear ➞ Left Rear ➞ Subwoofer in that order.

Test Tone

To End the Speaker Setup

•Press the Test Tone button again.

L C R

SUB

WOOFER

LSRS

	While in DSP or PRO LOGIC mode, TEST TONE may
37	operate differently for VCDs or CDs.