Samsung HT-HDP40 instruction manual Setting the Test Tone

Setting the Test Tone

Use the Test Tone feature to check the speaker connections.

Setting the DRC (Dynamic Range Compression) ENG

You can use this function to enjoy Dolby Digital sound when watching movies at low volume at night.

In Stop or no		Press Cursor		Press Cursor button
disc mode,		button to move to		to move to ‘TEST
1 press MENU	2	‘Audio’ and then	3	TONE’ and then press
		press ENTER button.		ENTER button.
button.

• The test tone will be sent to L ➝ C ➝ R ➝ SR ➝ SL ➝ SW in order.

If the ENTER button is pressed again at this time, the test tone will stop.

Press RETURN button to return to the previous level.

Press MENU button to exit the setup screen.

Alternate method: press the TEST TONE button on the remote.

1 In Stop or no disc mode, press MENU button.

Press Cursor 3 button to move to

‘DRC’ and then press ENTER button.

Press Cursor 2 button to move to

‘Audio’ and then press ENTER button.

4	Press		Cursor
		,		to adjust
	the		‘DRC’.
					SETUP
• When the Cursor				button is pressed,
the effect is greater, and when the
Cursor		button is pressed, the effect is
smaller.

Press TEST TONE button.

•Test tone will be produced as follows:

When playing a DVD or CD, this will work only in Stop mode.

•Use this function to check that each speaker is correctly connected and that there is no problem.

•When there is no input signal from the HDMI IN function, the Test Tone will not work.

To end the test tone,

press TEST TONE button again.

L: Front Speaker (L)	C: Center Speaker	SW: Subwoofer
R: Front Speaker (R)	SL: Rear Speaker (L)	SR: Rear Speaker (R)

Multi-Channel Pro Logic Mode

Start

Press RETURN button to return to the previous level.

Press MENU button to exit the setup screen.

53 54