The Document Company
XEROX
DC220/230ST Windows NT® 4.0 NetBIOS/IP Quick Install
Installation Requirements:
To install the DC220/230 into a DHCP environ- ment, exclude the addresses assigned to the DC220/230 at the DHCP server.
Before Installation:
Record the following information for use during setup at the DC220/230:
TCP/IP:
TCP/IP Address:_________________________
Gateway Address:_______________________
Subnet Mask:_________________________
Broadcast Address:______________________
Host Name:_____________________________
NetBIOS:
Host Name:_____________________________
Printer Name:___________________________
Workgroup:_____________________________
1. Connect the DC220/230 to your network outlet or cable.
2. Enter System Administration Setups:
a)Press the [Access] button on the Control Panel.
b)Enter the System Administrator password by typing #22222
(# key and 22222) on the keypad and pressing [Enter] on the screen.
Note: #22222 is the factory default password and may be changed by your Xerox service representative to suit your needs.
c)On the screen display, press [Print Setups].
d)Press [Network Setups].
Note: If TCP/IP has been installed, go to step 4. If TCP/IP has not been installed, continue with step 3.
3. Access the TCP/IP Network Setups screens:
a)Press [TCP/IP].
b)IP Address setup (skip this step if using RARP): Press [IP Address], then press [Edit] and use the key- board on the display screen to enter the static IP address for the DC220/ 230. This number is assigned by the System Administrator
OR
b)RARP setup (skip this step if using a static IP address): Press [RARP], then press [Enabled].
c)Press [Save].
d)Press [Gateway Address], then press [Edit] and use the keyboard on the display screen to enter the Gateway address of your network.
e)Press [Save].
f)Press [Subnet Mask], then press [Edit] and use the keyboard on the display screen to enter the Subnet Mask for your network (default is 255.255.255.0).
g)Press [Save].
For assistance, contact your local Xerox Customer Support Center: USA: