Xerox XR6 Series manual Method 2 Digital DVI Connection XR6-19Dw only

Page 15

Installation

Method 2: Digital (DVI) Connection (XR6-19Dw only)

1Turn off the computer and unplug the power cable.

2Connect the signal cable (DVI) to the DVI port on the back of the computer.

3Connect the power cord to the LCD monitor and wall outlet.

4Press the button, located on the bottom side of the main unit to turn the monitor on, then turn the computer on. If the monitor displays an image, the monitor is successfully installed. If no image is displayed, check all connections.

XR6-19Dw

2 Connect to the DVI port

3Connect to power source

NOTE:

When the DVI and VGA input ports are connected at the same time, press down the AUTO button after 3 seconds to switch between the VGA mode and DVI mode.

14	Xerox© LCD Monitor User’s Manual

Image 15

Contents LCD Monitor By Xerox Corporation. All rights reserved Table of Contents Europe Recycling PlaceCE Marking Declaration Of Conformity Federal Communications Commission FCC Statement Important Safety Instructions On next Collection service Introduction FeaturesPackage Contents Menu Front View and ControlsConnecting Your LCD Monitor to a Computer InstallationEnglish Method 2 Digital DVI Connection XR6-19Dw only Installing Your LCD Monitor OSD Menu Using the OSD MenuOSD Options Picture Menu Advanced Menu Options Menu Osd h. positionOsd v. position Languages Osd timeoutUtilities Menu Osd backgroundTechnical Information Preset Mode Timing ChartPIN Description DVI Connector PIN AssignmentSUB Connector PIN Assignment Plug and Play Visual InspectionPermanently unlit or lit pixels Poor picture or abnormal picture TroubleshootingMonitor will not turn on No pictureModel Speciﬁcations281 281 530-4104 Fax Hours 8AM ~ 6PM Central Time Authorized Service Centers