Xerox manual b Press, Press until, 7+2&8017&203$1, DC230LP Windows NT 4.0 TCP/IP Quick Install

Subnet Mask = (current entry)

displays.

7+(￿'2&80(17￿&203$1<

￿￿￿￿￿

DC230LP Windows NT® 4.0 TCP/IP Quick Install

b) Press [ ].	RARP	=	displays.
	(current entry)	*

c)Press [ ] until the required setting

displays RARP(required entry) = .

d)Press [Enter]. **SAVED** displays momentarily, followed by

RARP	> .
(your entry)

6. Enter the Gateway Address:

a)	Press [	] until		Default Gateway >
				(current entry)
	displays.
b)	Press [	].	Default Gateway		=	displays.
			(current entry)

Note: Use zeros to supplement each address segment if fewer than 3 digits are used; e.g., 13.252.25.08 = 013.252.025.008.

c)Use the [ ] or [ ] key to select the first digit in the Gateway Address.

d)Press [ ] to move to the next digit. Repeat this procedure to enter the entire Gateway Address.

e)Press [Enter]. **SAVED** displays momentarily, followed by

Default Gateway	>	.
(your entry)

7. Enter the Subnet Mask:

a)	Press [ ] until	Subnet Mask >
		(current entry)

b) Press [ ]. displays.

c)Use the [ ] or [ ] key to select the first digit of the Subnet Mask for your network.

d)Press [ ] to move to the next digit. Repeat this procedure to enter the entire Subnet Mask.

e)Press [Enter]. **SAVED** displays momentarily, followed by

Subnet Mask	> .
(your entry)

8. Enter the Broadcast Address:

Note: Broadcast Address is where all the host bits are set to either zeros (0) or ones (1).

a)	Press [	] until		Broadcast Addr	>
				(current entry)
	displays.
b)	Press [	].	Broadcast Addr =		displays.
			(current entry)

c)Use the [ ] or [ ] key to select the first digit in the Broadcast Address.

d)Press [ ] to move to the next digit. Repeat procedure to enter the entire Broadcast Address.

e)Press [Enter]. **SAVED** displays momentarily, followed by

Broadcast Addr	>	.
(your entry)

9. Enter the Printer (Host) Name:

Note: It is recommended that the Printer (Host) Name be the same as your Share Name.

a)	Press [	] until		Printer Name		>
				(current entry)
	displays.
b)	Press [	].	Printer Name		=	displays.
			(current entry)

c)Press [ ] repeatedly until the cursor reaches the last character. A tone sounds indicating when the last character has been reached.

Page 2 of 4