Printer Drivers

Xerox 2101

If jobs in the RIP queue are merged and finishing is applied to the merged job, not all the pages in the job may print and/or the desired finishing may not be applied. Before merging the jobs from the RIP queue, ensure that all the job properties (plex, finishing, etc.) are the same for all jobs including the final merged job.

It is recommended that jobs should be merged from the Spool (Hold) queue. The job properties (plex, finishing, etc.) of the merging jobs should be the same. Apply the desired job properties to the merged job.

When using the Impose feature for a PDF job or a one page document, if 2-up Saddle or 2-up Perfect are selected, change the paper stock to 8.5x11 before closing DocBuilderPro. Load 8.5x11 stock short edge feed (SEF). If the paper stock is left at 8.5x11P, the job will fault and you will not be able to print it.

Tray 7 Restrictions: Sheets fed from Tray 7 (Interposer) will

not be punched. Solution: Use pre-punched stock in Tray 7, if job requires punched paper.

Feeding A4 Premier TCF heavyweight stock from Tray 7 may result in excessive paper jams.

Under the Annotations feature, the word "Circular" is incorrect. It should be labeled "Circulate”.

Under the Annotations feature, no conflict checking exists. Pay special attention when utilizing this feature as it is possible to “stack” annotations on top of one another.

In all Microsoft Windows printer drivers the Two-Way Communication feature in the Installable Options tab of the Properties window is not available. You must set Installable Options manually as described in the Fiery EX2101 Printer Control Getting Started document. Note that in Microsoft Windows NT 4.0 the installable options are set in the Device Settings tab of the Properties window.

The Macintosh version OS X uses a different method for loading drivers than the OS 9x. Please follow the OS X driver installation instructions.

Xerox 2101	2-3
GETTING STARTED