Hardware Installation

PLEASE FOLLOW THIS INSTALLATION PROCEDURE EXACTLY. NOT DOING SO MAY RESULT IN KEYBOARD AND/OR MOUSE ERRORS, OR FAULTY OPERATION.

WARNING: Before attempting to connect anything to the OmniView™ SE or the computers, make sure everything is powered off. Plugging and unplugging cables may cause irreversible damage to your computers and the OmniView™ SE. Belkin Components will not be held responsible for damage caused.

1. Set the DIP switches. If you have only one OmniView™ SE, use the MASTER bank setting. If the OmniView™ SE you are using will be daisy-chained off another unit, use a unique slave setting. Please refer to the next section for more information regarding multiple OmniView™ SE units.

DIP switches 1 & 2 set the SCAN_TIME. See the USAGE section regarding this setting

Use this setting if you have only one OmniView™ SE

DIP SWITCH SETTINGS				BANK ADDRESS
				BANK ADDRESS
1	2	3	4
ON	ON	ON	ON	BANK 0	MASTER
ON	ON	OFF	ON	BANK 1	Slave
ON	ON	ON	OFF	BANK 2	Slave
ON	ON	OFF	OFF	BANK 3	Slave

DIP Switches 1&2 set scantime. See page 15 for AutoScan Mode DIP Switch settings.

NOTE: “ON” is down

2. Find a convenient place to put your OmniView™ SE. Take note of the length of your cables so that your computers, OmniView™ SE, keyboard, mouse, and monitor are distanced properly.

3. Connect the monitor to the OmniView™ SE. Using the attached cable, or the one included with your monitor, connect it to the HDDB15 female port on the back of the OmniView™ SE labeled with the monitor symbol at the CONSOLE section.

Monitor