Installation, Glossary of Terms | Belkin F1DC108B manual

OVERVIEW

Glossary of Terms

The following definitions are used throughout the User Manual:

AutoScan A mode of operation where the KVM Switch sequentially monitors all attached servers.

BANK The address of a KVM Switch when used in a daisy-chain configuration (BANK numbers range from 0 to 15); typically set by adjusting the DIP Switch to the appropriate setting.

Console The keyboard, video monitor, and mouse.

Console Ports The connectors on the back of the KVM Switch for connection of the console.

Control In terms of switching between ports, “control” means that the console is capable of sending input to the computer; requires that the console also has “focus” on the port, and is “viewing” it.

Daisy-ChainingThe process of connecting multiple KVM Switches together in a sequence with cables. Daisy-chaining allows the KVM Switches to interact with each other to expand control over servers.

Human Interface Device (HID) A USB device class that includes keyboards and mice.

IntelliView Graphical On-Screen Display (OSD) A graphical user interface that can be used to control and configure the KVM Switch.

KVM or KVM Switch A keyboard, video, and mouse switch.

Port Receptacle in the KVM Switch for plugging in a computer or input device.

Primary Switch A KVM Switch with a console attached to it and set to BANK address 0–3.

Secondary Switch Switches not assigned as “Primary Switch” that are connected in a daisy-chained KVM configuration. These are set to BANK addresses 4–15 and do not have a console connected directly to them.

Select Mode The mode of operation a daisy-chained KVM Switch enters when it receives the first button press from the front panel, in Static mode. Select mode allows the user to select BANKs, hosts, etc. with the next button press.

Standalone A single KVM Switch configured to function independently of other KVM Switches.

Static Mode The KVM Switch’s predominant mode of operation, into which it enters whenever it has not received a button press for at least five seconds.

View In terms of switching between ports, “viewing” means that the console is receiving video from the computer. Viewing requires that the console also has “focus” on the port.

INSTALLATION

Pre-Configuration

The enclosure of the Switch is designed for rack-mount configuration in a standard 19-inch server rack. Rack-mount hardware is included for a sturdy rack installation. Consider the following when deciding where to place the Switch:

•The location of your computers in relation to where you would like to install your Switch; and

•The lengths of the cables you use to connect your computers to the Switch.

Cable Distance Recommendations

For PS/2 Computers

We recommend that PS/2 cable length be limited to 25 feet for best video performance. Beyond that length, the probability of video degradation increases.

For USB Computers

We recommend that USB cable length be limited to 12 feet for best performance. Beyond 12 feet, the probability of signal failure is likely, and this may cause the device to fail.

Installing the Switch into a Server Rack

The included mounting brackets feature adjustable positions that allow the Switch to fit in virtually any four-post, 19-inch server rack.

1.Remove the adjustable brackets from the box.

2.Select a bracket-hole scheme based upon your server rack’s dept.

3.Attach the bracket to the side of your Switch with the Phillips screws provided.

4.Mount the Switch to the rack rail assemblies.

Note: If this Switch will be daisy-chained to another KVM Switch, set the BANK address prior to installing on a rack. Refer to the section in this User Manual labeled “Multiple KVM Switch—Installation (Daisy-Chaining)”.

*** Cautions and Warnings ***

Before attempting to connect anything to the Switch or your computer(s), please ensure that everything is powered off. Belkin Corporation is not responsible for damage caused by these actions.