Using Your E Series KVM Switch

2-Port

4-Port

INSTALLATION

CONNECT THE COMPUTER:

4. Connect the first computer’s VGA cable to the E Series KVM Switch. Using the VGA cable (Belkin Part# F3X1105-XX, F3X1835- XX, or F2N209-XX),

connect the male end of the cable to the VGA port on the computer, and the female end to the VGA port on the rear of the E Series KVM Switch labeled CPU1.

Powering up the Systems

Once all cables have been connected, power up the CPUs that are attached to the E Series KVM Switch. All computers can be powered on simultaneously. The E Series KVM Switch emulates a mouse and keyboard on each port and allows your computer to boot normally. Your Belkin E Series KVM Switch should now be ready for use.

You can select which computer to operate by either the push-button Selector Button located on the top panel of the E Series KVM Switch or through keyboard hot key commands. Note that it will take 1 to 2 seconds for the video to display after switching. This is due to the refresh of the video signal. There is also resynchronization of the mouse and keyboard signal that takes place. This is normal operation and ensures that proper synchronization is established.

5. Connect the first computer’s PS/2 keyboard and PS/2 mouse cable to the appropriate ports on the section labeled CPU1. (Belkin

Part# F3X1105-XX, F3X1835-XX, or F2N036-XX).

4-Port

2-Port

Selecting a Computer Using Front-Panel Selector Buttons

4-Port	2-Port

6.Repeat steps 4 and 5 for each additional computer you wish to connect.

You can directly select a connected computer by pressing the Selector Button on the switch. The LED will be lit above the number to indicate which port is currently selected.