INSTALLATIONEn

P74395ea_F5U231ea_uk 05-09-2003 14:51 Page 5

Important Note: Please do not connect any USB devices to the Hub until instructed to do so in step 4 of this installation procedure.

1.Plug the AC adapter into a wall outlet or surge suppressor. Plug the DC connector into the DC power jack found on the rear of the Hub.

Note: The Hub may be used without the power supply with most USB devices

2.Plug the flat end (USB-A connector) of the provided USB device cable into the downstream port of your computer or downstream port of another hub. Plug the square end (USB-B connector) into the USB-B connector on the back of the Hub.

Important Note: The Hub must be connected to a USB 2.0-compliant host in order to function in high-speed mode (480Mbps data rate). If the Hub is connected to a USB 1.1-compliant host, it will operate only in low-speed or full-speed mode (1.5Mbps/12Mbps).

3.Windows will now detect your Hub and install the required driver support. (The Windows “Install New Hardware Wizard” may prompt you to provide your Windows Installation CD to complete the driver installation process).