Teac HD-1 Listening to the Radio, Storing Preset Stations, How to select a preset station

Listening to the Radio

Extend the FM wire antenna fully for best reception (do not strip, alter or attach to other antennas). The AM loop antenna should be placed up to 12" away from the unit for best reception. Rotate the AM loop antenna as required for best reception.

	2
1		3

1Press the STANDBY/ON button to turn on the unit.

2Press the FUNCTION/WAKE TO button on the HD-1 to select AM or FM band to listen to the radio. The radio frequency appears at the center of the display.

3Turn the TUNING/SELECT knob on the HD-1 (or press

.or / on the remote control) to tune in the desired station. Press and hold the . or/ on the remote control for 2 seconds to Auto scan to the next clear station.

Storing Preset Stations

This unit allows you to program 20 stations on FM band and 10 stations on the AM band.

1Turn the TUNING/SELECT knob on the HD-1 (or press . or/ on the remote control) to tune to the station you wish to store.

2Press the MEMORY button once to store the station.

3While preset number indicator flashing on the display, press PRESET button repeatedly to select preset station.

4Press MEMORY button again to confirm after your preset number selected.

To store more stations, repeat steps 1 to 3 .

How to select a preset station

1To select FM or AM, press the FUNCTION/WAKE TO button.

2Press the PRESET button on the unit repeatedly until the desired preset station is found.

NOTE :

•If the preset memory mode is open and no button is pressed for 10 seconds, the preset memory mode will quit unless the MEMORY button is pressed before then to confirm and close the preset memory mode. No frequency will be stored after the 10 seconds runs out.

12

HD-1.indd 12

2008.12.17 9:19:34 AM