Belkin F5D7634-4A-H user manual Manually Configuring Network Adapters, Windows 98SE or Me

Manually Configuring Network Adapters

Table of Contents sections 1 2 3 4 5 6 7 8 9 10

Windows 98SE or Me

1.Right-click on “My Network Neighborhood” and select “Properties” from the drop-down menu.

2. Select “TCP/IP -> settings”	(1)	(2)	(3)
for your installed network
adapter. You will see the
following window.

3.If “Specify an IP address” is selected, your Router will need to be set up for a static IP connection type. Write the address information

in the table below. You will need to enter this information into the Router.

4.Write down the IP address and subnet mask from the “IP Address” tab (3).

5.Click the “Gateway” tab (2). Write down the gateway address in the chart.

6.Click the “DNS Configuration” tab (1). Write down the DNS address(es) in the chart.

7.If not already selected, select “Obtain an IP address automatically” on the “IP Address” tab. Click “OK”. Restart the computer. When the computer restarts, your network adapter(s) are now configured for use with the Router. Set up the computer that is connected to the cable or DSL modem by FIRST using these steps. You can also use these steps to add computers to your Router after the Router has been set up to connect to the Internet.

G Wireless Modem Router 58