1150 King Georges Post Rd. Edison, NJ
System Sales Team
USB2.0 Installation Procedure
Before beginning installation:
•Must have a TSP600 (TSP613/643), TSP700 (TSP743) or TSP800 (TSP847) with USB2.0 ready firmware.
Printer | Firmware Version |
TSP613 / TSP643 | Ver3.2 |
TSP743 | Ver3.2 |
TSP847 | Ver4.3 |
***Note: If you have a firmware version that was releases prior to the
•Printer being used must have USB2.0 chip on printer USB interface card
*** Note: Interface version can be determined by removing interface card from the back of the printer ***
• If the printer being used has the appropriate firmware version, change the dip switches as follows:
Dip Switch 1- 5 / 1- 6 | Functionality | Application | |
Vender Class | OPOS | ||
Printer Class | Normal Windows Operation | ||
• If Using the printer with OPOS, the Star Micronics OPOS drivers (Version 1.4.11 or higher) and the Vender Class Drivers will be required
***Note: If you do not have Version 1.4.11 of the OPOS driver or the Vender Class Driver, please call a Star Micronics Customer Support Specialist today ***
Once all steps above are completed, installation of the USB port can occur.
To begin installation of the ‘Printer Class’ USB port, go to the next page To begin installation of the ‘Vender Class’ USB port, go to page 7
To begin installation of the ‘OPOS Drivers’, go to page 14
To start the ‘Add Hardware Wizard’, click on ‘My Computer Control Panel Add/Remove Hardware.
The ‘Add / Remove Hardware Wizard’ will open (see next page…)
Page 2