2. Click Internet Protocol (TCP/IP) and
then click Properties. Then click on
Obtain an IP address automatically.
Fourth, press on the factory reset button for 15 seconds.
Note: If you are trying to configure the
Q2: I am not sure what type of Internet Account Type I have for my Cable/DSL connection. How do I find out?
A2: Contact your Internet Service Provider's (ISP) support service for the correct information.
Q3: I went through the Wizard, but I can not get onto the Internet. What should I do?
A3: First, verify that you can get onto the Internet with a direct connection into your modem. Second, contact your ISP and verify all the information that you have in regards to your Internet connection settings is correct. Third, power cycle your modem and router. Unplug the power to the modem and router. Wait 30 seconds, and then reconnect the power to the modem. Wait for the modem to fully boot up, and then reconnect the power to the router.
Q4: I can not make a wireless connection to the
Q5: What is the USB cable for?
A5: You can use the USB cable to power the
10