Transition Networks SM24-100SFP-AH Installing the Switch, Selecting a Site, Equipment Checklist

Chapter 3: Installing the Switch

Selecting a Site

Switch units can be mounted in a standard 19-inch equipment rack or on a flat surface. Be sure to follow the guidelines below when choosing a location.

•The site should:

•be at the center of all the devices you want to link and near a power outlet.

•be able to maintain its temperature within 0 to 45 °C (32 to 113 °F) and its humidity within 10% to 90%, non-condensing

•provide adequate space (approximately two inches) on all sides for proper air flow

•be accessible for installing, cabling and maintaining the devices

•allow the status LEDs to be clearly visible

•Make sure twisted-pair cable is always routed away from power lines, fluorescent lighting fixtures and other sources of electrical interference, such as radios and transmitters.

•Make sure that a separate grounded power outlet that provides 100 to 240 VAC, 50 to 60 Hz, is within 2.44 m (8 feet) of each device and is powered from an independent circuit breaker. As with any equipment, using a filter or surge suppressor is recommended.

Equipment Checklist

After unpacking the switch, check the contents to be sure you have received all the components. Then, before beginning the installation, be sure you have all other necessary installation equipment.

Package Contents

•SM24-100SFP-AH Fast Ethernet Switch

•Four adhesive foot pads

•Bracket Mounting Kit containing two brackets and eight screws for attaching the brackets to the switch

•Power Cord

•RS-232 console cable

•This Installation Guide

•Management Guide CD

3-1