TRENDnet TEW-649UB manual Identifying External Components, WPS Button

Page 8

IDENTIFYING EXTERNAL COMPONENTS

LED

LED Status

Slow Blink (1 blink/second)

Fast Blink (3 blinks/second)

Off

Description

When the LED is blinking, the WLAN Adapter is transmitting or receiving data on the Wireless Ethernet network.

After pressing the WPS button, the LED will flash 3 blinks/second. Once the connection is successfully established between the AP and the adapter, the LED will remain solid for 5 seconds to tell the users that the connection has been established. After 5 seconds , the LED will turn off to indicate that the AP is ready for a new WPS connection and the adapter is associated with the AP.

User inserts the card into the NB without driver installed, and without connection.

WPS Button

Press the WPS button start the WPS pairing, the LED will begins to blinking for 3 blinks/second, once the connection is successfully established between the AP and the adapter, the LED will remain in solid for 5 seconds to tell the users that the connection has been established. After 5 second, the LED will light off to indicate user that the Access Point or Wireless Router is ready for a new WPS connection and the adapter is associated with the Access Point or Wireless Router.

7

Image 8
Contents Page Federal Communication Commission Interference Statement 0560 Page Table of Content Introduction System Requirements Unpacking and SetupUnpacking Identifying External Components WPS ButtonWireless Performance Considerations Software Installation Windows Based Utility InstallationDriver Installation Page Click Continue Anyway Click Finish Windows Click Yes Wireless Utility Setting Link InformationConfiguration Open or Shared Key WPA‐PSK / WPA2‐PSK WPA EAP‐TLS Site Survey Profile Page WPS Page Enter a PIN into my access point Page Page About Technical Specifications HardwareLimited Warranty