Transition Networks E-PSW-TX-02 technical specifications Technical Specifications

Page 1

TRANSITION NETWORKS’ POCKET SWITCH

TECHNICAL SPECIFICATIONS

Standards

IEEE 802.3, IEEE 802.3u

Dimension

4.75" X 5.75" X 1.0"(120mm x 146mm x 25mm)

Power Supply

NOTE: Replace power supply only with the equivalent input rating (see below) and output rating (regulated 12VDC at 1.5 A).

TN PN

Requirement

Location

3507

240 volts, 50 hertz

United Kingdom

3342

230 volts, 50 hertz

Europe

3340

120 volts, 60 hertz

USA/Canada/Mexico

3346

100 volts, 50-60 hertz

Japan

3511

240 volts, 50 hertz

Australia

3537

(with power cord: 3522)

South Africa

Environment

Temperature:

0-50°C (32° to 122° F )

Humidity

10-90%, non condensing

Altitude

0-10,000 feet

Warranty

Lifetime

Transition Networks’

Pocket Switch

(E-PSW-TX-02, E-PSW-FX-02)

33015.B

For assistance in installing, using, or maintaining the TRANSITION Networks Pocket Switch, contact TRANSITION Networks Technical Support at:

(800) 260-1312

or contact your local distributor.

29

Transition Networks’

Image 1
Contents PSW-TX-02, E-PSW-FX-02 Technical Specifications100BASE-FX Cable Specifications 100BASE-FX Cable and Connector Specifications100BASE-FX Connector Characteristics 10BASE-T/100BASE-TX Cable and Connector Specifications Ethernet Cable SpecificationsTable of Contents Features Transition Networks’ Pocket SwitchesIntroduction Evolving Ethernet Network Warranty StatementFault Isolation MaintenanceNetwork Flexibility Technical Support ContactConnectors Connectors, Switches, and IndicatorsLED Indicators Switches at surface opposite connectorsEthernet Switching Powering Transition Networks’ Pocket SwitchEthernet CSMA/CD Protocol Connecting Fiber Cable to TX/RX Connectors Installing Network CableInstalling Cable MAC Address TableConnecting Twisted-Pair Copper Cable to RJ-45 Connector Doubling Bandwidth by Installing Full-DuplexLegacy CSMA/CD Ethernet is Half-Duplex Microsegmented Ethernet Link is Full-DuplexStraight-Through/Crossover 10BASE-T /100BASE-TX Switch to Terminal connections mustNIC, printer Calculating RTD Round Trip Delay Connecting Legacy Ethernet to Fast EthernetLegacy Ethernet and Fast Ethernet Migrating from Legacy Ethernet to Fast EthernetAuto-Negotiation 5-Segment Rule 10BASE-TAssigning Segment Numbers Half-duplex Fiber Increasing Network Distance by Installing 100BASE-FXFull-duplex Fiber Class I and Class II Fast Ethernet Repeaters Setting DIP SwitchUnpacking the Transition Networks’ Pocket Switch InstallationInstalling on Flat, Stable Surface Site Considerations