Summit E323, E-321 service manual Printing a Test

Lexmark E-321/E323 Toner Cartridges (Continued)

Figure 34 Figure 35

29)With the springs in the correct position, bend the drum cover slightly in the middle. Place the alignment pins in their respective slots. Try to make sure the large tail of the spring fits in place as you fit the cover in place. See Figure’s 34 & 35

The cartridge is finished! If you are testing the cartridge, (Highly recommended) a test page can be generated from the machine, but it is not an easy process. It is easier and faster to generate pages from an Anacom box, or a computer.

30) Once the testing is finished, make sure you install the shipping lock.

Printing a Test page:

As stated above running test prints from the machine itself is not an easy task. It is easier and faster to run tests from an Anacom box, or a computer.

If you need to run prints from the machine do the following:

1)Turn the printer off.

2)Open the top cover.

3)Press and hold the “CONTINUE” button as you turn the printer back on. All the lights will cycle.

4)Release the “CONTINUE” button, close the cover.

5)Press and hold the “CONTINUE” button until all the lights cycle.

6)The Printer will print the Configuration Page.

Light Sequences:

The more common problems such as Toner Low and Paper Jam have their own lights and are self-explanatory. I will list some of the less apparent sequences here.

Toner Low Blinking, Error on steady: Toner cartridge error

Toner Low Blinking, Error Blinking: Wrong Toner cartridge (Probably an IBM, or E320)

Error light on steady: Top Cover Open

DOC-0331 Page 11 www.summitlaser.com