Summit S93WD462, S93WD463 manual Read, Write

S93WD462/S93WD463

Instructions, addresses, and write data are clocked into the DI pin on the rising edge of the clock (SK). The DO pin is normally in a high impedance state except when reading data from the device, or when checking the ready/busy status after a write operation.

The ready/busy status can be determined after the start of a write operation by selecting the device (CS high) and polling the DO pin; DO low indicates that the write operation is not completed, while DO high indicates that the device is ready for the next instruction. See the Applications Aid section for detailed use of the ready busy status.

The format for all instructions is: one start bit; two op code bits and either six (x16) or seven (x8) address or instruction bits.

Read

Upon receiving a READ command and an address (clocked into the DI pin), the DO pin of the S93WD462/ WD463 will come out of the high impedance state and, will first output an initial dummy zero bit, then begin shifting out the data addressed (MSB first). The output data bits will toggle on the rising edge of the SK clock and are stable after the specified time delay (tPD0 or tPD1).

Write

After receiving a WRITE command, address and the data, the CS (Chip Select) pin must be deselected for a minimum of 250ns (tCSMIN). The falling edge of CS will start automatic erase and write cycle to the memory location specified in the instruction. The ready/busy status of the S93WD462/WD463 can be determined by selecting the device and polling the DO pin.

	tSKHI	t SKLOW	t CSH
SK
	tDIS		tDIH
DI	VALID		VALID
	tCSS
CS
		t DIS	tPD0,t PD1	tCSMIN
DO			DATA VALID
	Figure 1. Sychronous Data Timing			2029 ILL 3.0

SK
									tCS
CS
									STANDBY
			AN	AN–1	A0
DI	1	1	0
				tPD0					tHZ
DO			HIGH-Z		0				HIGH-Z
						DN	DN–1	D1	D0
									2029 ILL4.0
				Figure 2. Read Instruction Timing
SUMMIT MICROELECTRONICS, Inc.				2029	2.2	1/23/01			3