Fujitsu 280X1024@75Hz manual Important Precautions

Page 3

EMC COMPLIANCE

EMC COMPLIANCE

This device has been tested and found to comply with the standards for a class B digital device, pursuant to Part 15 of FCC Rules. Those standards are designed to provide reasonable protection against harmful interference in a residential installation. This device generates and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.

If this device does cause harmful interference to radio or television reception, which can be determined by turning the device off and on, user is encouraged to try to correct the interference by one or more of the following measures:

---Reorient or relocate the receiving antenna

---Increase the separation between the device and receiver

---Plug the device into a wall outlet different from that connected to the receiver.

---Consult the dealer or an experienced radio/TV technician for help.

CAUTION: any change or modification not expressly illustrated in this manual may void the warranty.

NOTE: any unshielded cable is not allowed to be used in the device!

IMPORTANT PRECAUTIONS

IMPORTANT PRECAUTIONS

WARNINGS:

1.Before using this device, please read all the instructions in this manual carefully.

2.Please keep the manual carefully for future reference.

3.Unplug this device from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp or wet cloth to clean. Please use LCD screen detergent for cleaning if it is still dirty.

4.Do not use the parts not recommended by the manufacturer, otherwise it may cause a hazard.

5.When unplugging the power cord of the monitor or adapter, please hold the plug with your hand; do not pull the cord directly.

6.Do not place any object on the power cord. Do not trample it either.

7.Do not use the device near water sources, e.g. bathtub, basin, kitchen sink, or washing machine. Do not place the device on a wet floor, or near a swimming pool etc. Do not touch the screen with your fingers or other hard objects.

8.Slots and openings on the housing and its back or bottom are provided for ventilation. To ensure reliable operation of the components and to protect them from overheating, these openings must not be blocked or covered placing the device on a bed, sofa, rug, or other similar surface. The device should never be placed near or over a radiator or heater and should not be placed in a built-in installation unless proper ventilation is provided.

9.Make sure that the device is at least 5cm distance from the wall or other objects around when it is in use.

10.The power supply must respond to that stated on the rating plate. If you have any query about the power supply, please refer to the dealer or local power supply provider.

11.As a safeguard measure, the monitor or adapter is equipped with a power cord with three-terminal plug, the third terminal is grounded. If the plug cannot be inserted into the outlet, please contact an electrical technician for replacing the original outlet while keeping the safeguard measure in effect.

12.Ensure that the power socket and cord in use are able to take the sum of the rated currency of all the products.

13.Do not put the device at the place where user is subject to mal-operation.

page 1

page 2

Image 3
Contents Inch Color LCD Monitor Table of Contents Important Precautions Features GeneralPacking list Image Adjustment Connection of signal cableConnection of power cord Power onMenu Button Power SwitchPower Indicator OSD buttonOSD menu and operation menu introduction Brightness adjust menuSetting of display mode Safeguard22 TFT-LCD monitor specification Power management systemThere is no Screen Image/LED light red Pin assignment of signal cableDark display after power on/ facula Visual Inspection