Fujitsu V1010 Drive1 Submenu of the Main Menu, Following Set-up items do not appear, Is selected

M a i n M e n u

Drive1 Submenu of the Main Menu

The Drive1 submenu allows you to configure secondary ATA devices, such as an optical drive.

PhoenixBIOS Setup Utility

Main

Drive1 [HL-DT-ST DVDRAM_GSA-T20N]		Item Specific Help
Type:	[Auto]	Select Serial ATA/ATAPI
Multi-Sector Transfers:	[Disabled]	drive installed here.
LBA Mode Control:	[Disabled]	[Auto]
Transfer Mode:	[Standard]	The BIOS auto-types the
Ultra DMA Mode:	[Disabled]	drive on boot time.
		[None]
		The drive is disabled.

F1	Help	Select	Item
ESC	Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 3. Drive1 Submenu

Table 3: Fields, Options and Defaults for the Drive1 Submenu of the Main Menu

Menu Field	Options		Default	Description
Type:	■	Auto	[Auto]	NOTE: The Type field does not appear as a drop-down menu. Tap
	■	None		the spacebar to cycle through the selections.
				Selects the ATA/ATAPI device type. Select Auto to have the type
				automatically identified by the BIOS at POST. If None is selected, all
				of the following Set-up items do not appear.
Multi-Sector	■	Disabled	[Disabled]	This option cannot be changed when Auto is selected. Specify the
Transfers:	■	2 Sectors		number of sectors per block for multiple sector transfer.
	■	4 Sectors
	■	8 Sectors
	■	16 Sectors
LBA Mode	■	Disabled	[Disabled]	Enables or disables Logical Block Addressing in place of Cylinder,
Control:	■	Enabled		Head, Sector addressing. This option cannot be changed when Auto
				is selected.

7