Fujitsu T4010D manual Primary Master Submenu of the Main Menu, Auto

L i f e B o o k T S e r i e s T a b l e t P C

Primary Master Submenu of the Main Menu

The Primary Master submenu identifies what ATA devices are installed.

Note that actual hard drive label shown may vary. Depending on the drive type, information such as cylin- ders, heads and sectors may also be displayed.

PhoenixBIOS Setup Utility

Main

Primary Master [FUJITSU MHT2040AT-(PM)]		Item Specific Help
Type:	[Auto]	Select ATA/ATAPI drive
LBA Format		installed here.
Total Sectors:	78140160
Maximum Capacity:	40008MB	[Auto]
		The BIOS auto-types the
Multi-Sector Transfers:	[16 Sectors]	drive on boot time.
LBA Mode Control:	[Enabled]
Transfer Mode:	[Multiword DMA 2]	Except [Auto]
Ultra DMA Mode:	[Disabled]	You enter parameters of
		the drive.
		[None]
		The drive is disabled.

F1	Help	Select	Item
ESC	Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 2. Primary Master Submenu

Menu Field	Options		Default	Description
Type:	■	Auto	[Auto]	Selects the ATA/ATAPI device type. Select Auto to have the type
	■	None		automatically identified by the BIOS at POST. If None is selected, all
	■	CD-ROM		of the following Set-up items do not appear. Select CD-ROM if a
	■	Hard Disk		CD-ROM drive is installed at this connection. If Hard Disk is
				selected, you must specify the number of Cylinders, Heads, and Sec-
				tors for the drive.
LBA Format				Logical Block Addressing (LBA)
Total Sectors:	---		---	The total number of sectors on your hard disk
Maximum	---		---	The maximum capacity of your hard disk
Capacity:
CHS Format				Cylinders/Heads/Sectors
Cylinders:	■	A number between	–—	This item is active only when Hard Disk is selected as the type. This
		0 and 65,535		field is changed by incrementing (pressing the [Spacebar]) or by typ-
				ing in the number.

6