Fujitsu T4020D manual Serial ATA Port 0 Submenu of the Main Menu, Auto

L i f e B o o k T S e r i e s T a b l e t P C

Serial ATA Port 0 Submenu of the Main Menu

The Serial ATA Port 0 submenu identifies what Serial ATA/IDE devices are installed.

Note that actual hard drive label shown may vary. Depending on the drive type, information such as cylin- ders, heads and sectors may also be displayed.

PhoenixBIOS Setup Utility

Main

Serial ATA Port 0 [FUJITSU MHT2040BH-SATA]		Item Specific Help
Type:	[Auto]	Select Serial ATA/IDE
	LBA Format	drive installed here.
Total Sectors:	78140160
Maximum Capacity:	40008MB	[Auto]
		The BIOS auto-types the
		drive on boot time.
		[None]
		The drive is disabled.

F1	Help	Select	Item
ESC	Exit	Select	Menu

-/Space	Change	Values
Enter	Select	▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 2. Serial ATA Port 0 Master Submenu

Menu Field	Options		Default	Description
Type:	■	Auto	[Auto]	Select Auto to have the type of Serial or Parallel ATA device automatically identified
	■	None		by the BIOS at POST. If None is selected, the following Set-up items do not appear.
LBA Format				Logical Block Addressing (LBA)
Total Sectors:	---		---	The total number of sectors on your hard disk
Maximum Capacity:	---		---	The maximum capacity of your hard disk

■A bootable CD-ROM or DVD-ROM may have a floppy disk or hard drive format. When a bootable CD-ROM or DVD-ROM is used, drive allocations change automatically without changing the BIOS setup. If a floppy disk for- mat CD-ROM or DVD-ROM is used, the disc becomes Drive A. The CD-ROM or DVD-ROM will only take drive C: (hard drive format) if the internal hard drive is not present or is disabled. The bootable CD-ROM or DVD-ROM can never use a C: designation if a formatted internal hard drive is present since the C: designator is always reserved for the internal hard drive.The boot sequence ignores the new drive designations, however, your applica- tion software will use the new designations.

■Be careful of the operating environment when booting from CD-ROM?DVD-ROM or you may mistakenly over- write files.

6