Fujitsu P-2040 manual Primary Master Submenu of the Main Menu, Exit

Primary Master Submenu of the Main Menu

The Primary Master submenu identifies which ATA devices are installed.

M a i n M e n u

Note: Actual hard drive label shown may vary. Depending on the drive type, information such as cylinders, heads and sectors may also be displayed.

		PhoenixBIOS Setup Utility
Main	Advanced	Security			Power	Boot	Info	Exit
	Primary Master [FUJITSU MHM2200AT-(PM)]							Item Specific Help
Type:							Select ATA/ATAPI drive
				[Auto]
Cylinders:			[16383]				installed here.
Heads:			[16]				[Auto]
Sectors:			[63]
Maximum Capacity:			8455MB				The BIOS auto-types the
							drive on boot time.
Multi-Sector Transfers:			[16 Sectors]				Except [Auto]
LBA Mode Control:			[Enabled]
PIO Transfer Mode:			[FAST PIO 4]				You enter parameters of
DMA Transfer Mode:			[Ultra DMA 4]				the drive.
							[None]
							The drive is disabled.

F1 Help	Select	Item
ESC Exit	Select	Menu

-/SpaceChange Values

Enter Select ▲ Sub-Menu

F9 Setup Defaults

F10 Save and Exit

Figure 2. Primary Master Submenu

Table 2: Fields, Options and Defaults for the Primary Master Submenu of the Main Menu

Menu Field	Options	Default	Description
Type:	• Auto	[Auto]	Selects the ATA/ATAPI device type. Select Auto to have the type
	• None		automatically identified by the BIOS at POST. If None is selected, all
	• Hard Disk		of the following Set-up items do not appear. If Hard Disk is
	• CD-ROM		selected, you must specify the number of Cylinders, Heads, and
			Sectors for the drive. Select CD-ROM to select parameters for CD-
			ROM drive.
Cylinders:	• A number	–—	This item appears only when the type is identifed as Hard Disk.
	between 0		When Hard Disk is selected, you can change the value. This field is
	and 65,535		changed by incrementing (pressing the [Spacebar]) or by typing in
			the number.
Heads:	• A number	–—	This item appears only when the type is identifed as Auto or Hard
	between 1		Disk. When Hard Disk is selected, you can change the value. This
	and 16		field is changed by incrementing (pressing the [Spacebar]) or by
			typing in the number.

5