Serial Ports Submenu
The Serial Ports submenu allows you to select the port addresses and interrupts for the COM and IR ports.
Serial Ports
COM A I/O Settings:
( ) Disabled
(*)COM1, 3F8, IRQ 4 ( ) COM2, 2F*, IRQ 3 ( ) COM3, 3E8, IRQ 4 ( ) COM4, 2E8, IRQ 3
Infrared Port I/O Settings:
( ) Disabled
( ) IR1, 2100, IRQ 4
(*)IR2, 2200, IRQ 3 ( ) IR3, 2300, IRQ 4 ( ) IR4, 2400, IRQ 3
OKCancel
Figure 12. Serial Ports submenu
The Serial Ports submenu consists of two sections:
■COM A I/O Settings
■Infrared Port I/O Settings
The COM A I/O Settings section allows you to select which port address and interrupt will be used for COM port A. COM1,3F8,IRQ4 is the default setting. To select a different address and interrupt, use the up and down arrow to choose a different one.
The Infrared Port I/O Settings section allows you to select which port address and interrupt will be used for COM port B (infrared port). IR2,2200,IRQ3 is the default setting. To select a different address and inter- rupt, use the up and down arrow to choose a different one.
C o m p o n e n t s M e n u
LPT Port submenu
The LPT Port submenu allows you to select the port addresses and interrupts for the internal printer port.
|
| LPT Port |
|
Port Address | Port Definition | ||
( ) | None | ( ) | Standard AT (Centronics) |
(*) LPT1, 378, IRQ 7 | (*) | Bidirectional (PS/2) | |
( ) | LPT2, 278, IRQ 5 | ( ) | Enhanced Parallel (EPP) |
( ) | LPT3, 3BC, IRQ 7 | ( ) | Extended Capabilities (ECP) |
DMA Setting For ECP Mode
(*)DMA 0 ( ) DMA 1 ( ) DMA 2
OKCancel
Figure 13. LPT Port submenu
The LPT Port submenu consists of three sections:
■Port Address
■Port Definition
■DMA Settings For ECP Mode
The Port Address section allows you to select which port address and interrupt will be used for the internal parallel (LPT) port. This is also known as the parallel port. LPT1,378,IRQ7 is the default setting. To select a different address and interrupt, use the up and down arrow to choose a different one.
The Port Definition section allows you to assign advanced capabilities to an attached device that supports the capabilities. Bidirectional
Standard AT (Centronics), Enhanced
Parallel (EPP), or Extended Capabilities (ECP), use the up and down arrows to choose a different one.
Note that Extended Capabilities (ECP) must be selected in order to enable the DMA Setting For ECP Mode section.
The DMA Setting For ECP Mode section allows you to set the DMA channel for the parallel port if ECP Mode is selected in the Port Definition section. DMA 0 is the default setting.
11