ASCII Fxxxx.x<CR> Sets the concentration factor to xxxx.x. For example: F1000<CR> will set the factor to 1000.
Note <CR> is an ASCII carriage return character.
The last three commands provide an output which can readily be incorporated into most spreadsheet software packages.
6.2 RS232 Output
The
The connections are as follows: |
| ||
TXD 2 | - INPUT TO 6300 | ||
RXD 3 | - OUTPUT FROM 6300 | ||
RTS 4 | - LINKED TO CTS | ||
CTS 5 | - LINKED TO RTS | ||
DSR 6 | - OUTPUT FROM 6300 | ||
DCD 8 | - OUTPUT FRM 6300 | ||
DTR 20 | - INPUT TO 6300 (must be active) | ||
GND 7 |
|
|
|
Suggested interconnections are detailed below: | |||
6300 |
| IBM PC XT (25 way “D”) | |
TXD 2 |
| 2 | TXD (From PC) |
| |||
RXD 3 |
| 3 | RXD (To PC) |
| |||
RTS 4 |
| 4 | RTS (From PC) |
| |||
CTS 5 |
| 5 | CTS (To PC) |
| |||
DSR 6 |
| 6 | DSR (To PC) |
| |||
DCD 8 |
| 8 | DCD (To PC) |
| |||
DTR 20 |
| 20 | DTR (From PC) |
| |||
GND 7 |
| 7 | GND |
| |||
6300 |
| IBM PC XT (9 way “D”) | |
TXD 2 |
| 3 | TXD (From PC) |
| |||
RXD 3 |
| 2 | RXD (To PC) |
| |||
RTS 4 |
| 7 | RTS (From PC) |
| |||
CTS 5 |
| 8 | CTS (To PC) |
| |||
DSR 6 |
| 6 | DSR (To PC) |
| |||
DCD 8 |
| 1 | DCD (To PC) |
| |||
DTR 20 |
| 4 | DTR (From PC) |
| |||
GND 7 |
| 5 | GND |
| |||
NOTE: | The Interface Cable Kit (Order Code: 542 009) can be used to implement the | ||
| above interconnections. | ||
Recorder Output
This is available via the 4mm rear panel sockets. The level is proportional to the displayed reading, de- pending on the measurement mode:
Transmission
Absorbance
Concentration
6300/REV