6.Remove the old hard disk drive from the blue bracket by flexing the bracket. Do not touch the circuits 5 on the hard disk drive.
7.Insert the new hard disk drive into the blue bracket aligning the pins 1 through 4on the bracket with the holes in the hard disk drive.
8.Insert the hard disk drive into hard disk bay with the circuits facing up and snap it into position.
9.Connect a power connector to the drive.
10.Reconnect the CD drive cable.
11.Lower the drive bay assembly into the original position.
12.Close the cover and reconnect the external cables . Go to “Completing the installation.”
Completing the installation
After replacing the CRUs, you need to close the cover and reconnect cables, including telephone lines and power cords. Also, depending on the CRU that was replaced, you might need to confirm the updated information in the IBM Setup Utility program. See ″Starting the IBM Set Utility″ in your Quick Reference.
To complete the CRU installation:
1.Ensure that all components have been reassembled correctly and that no tools or loose screws are left inside your computer. See “Locating components” on page 2 for the location of various components.
2.Correctly route all power supply cables to avoid interference with the drive bay assembly, and fold the ribbon cables 1 and 2along the existing crease lines.