S T E P 
Startup
Connect the PC to the ETERNUS DX60/DX80 with a LAN cable (for operation management), and turn on the ETERNUS DX60/ DX80.
n"7.1 Setup Preparation" in the "User Guide" | Power switch | |
n"7.2 Basic Setup" in the "User Guide" | ||
|
IMPORTANT The first time the power is turned on, volume formatting may start according to the factory
default settings. This does not affect the setup operation, which may be started immediately.
Controller Enclosure
S T E P 
Basic Setup
Basic ETERNUS DX60/DX80 setup is performed by accessing the "Initial Setup" and "Configuration Wizard" functions with a Web browser.
1.Start the Web browser on the PC and enter either of the following URLs in the address bar of the Web browser.
http://192.168.1.1/
https://192.168.1.1/
2.Enter the following user name and password, and click the [Logon] button to logon to the ETERNUS DX60/DX80.
User name: root
Password: root (Default)
3.After logging on, the Storage System Status screen appears.
Point When ETERNUS SF Express is used, perform the following setup, and then refer to the "ETERNUS SF Express User's Guide" to install the ETERNUS DX Disk storage system.
Initial Setup
●Set Date and Time
●Set Storage System Name
●Change Password
●Setup Network Environment
Initial Setup
Set the necessary environment for operating the ETERNUS DX60/DX80 with its initial setup.
The [Initial Setup] screen appears by clicking the [Initial Setup] menu on the [Easy Setup] tab.
This screen is used to set the following items:
nSet Date and Time
nSet Storage System Name
nChange Password
nSet SAS Port Parameters
nSetup Network Environment
After completing these settings with the Finish step, close the web browser to end the setup session, then detach the direct connection LAN cable (for operation management) from the PC and connect it to the normal network. Then try logging on again via the normal network, using the IP address that has just been set.
"7.2.1 Initial Setup" in the "User Guide"
Configuration Wizard
Perform the necessary settings to operate the ETERNUS DX60/DX80 using the Configuration Wizard.
The [Configuration Wizard] screen appears by clicking the [Configuration Wizard] button on the [Easy Setup] tab.
n Create RAID Group | n Configure Affinity Group |
n Create Volume | n Define LUN Mapping |
n Define Host |
|
"7.2.2 Configuration Wizard" in the "User Guide"
Point Default RAID groups, volumes and affinity groups are preset in the factory. Refer to "Web GUI User Guide" if the preset values are to be changed.
Assigning Hot Spares
Register hot spares for use in case the regular disks fail.
The [Assign Hot Spare] screen appears by clicking [Assign Hot Spare] under the [RAID Group Management] menu on the [Volume Settings] tab.
"7.2.3 Hot Spare Registration" in the "User Guide"
Point Check the factory settings and register a hot
spare as required.