IBM HOTR manual HOTS/HS64 Format, Hots

									ZTEST HOTX
HOTS/HS64 Format
>>--ZTEST--	+----	+-----		--+--HOTS-+---------------------------------------					>
	'- i-'			'--HS64-'
>-+- -Set-+-----------			+ -+			.-Ordinal-0-. --------		+	---+---><
					+ -+-----------		+ -+
	+- -FIleadd-+			+-Normal-----	+	+-Ordinal-n-+ +-FCt----		+
	'- -FAcid---		'	+-SNippets---	+	'-All-------	' '-NOFCt--	'
				+-NOSNippets-+
				+-STate------	+
				'-SErvice----	'
'- -Help-----------------------------------------------------------									'

i

indicates the specific I-stream in which the driver will be run. If i is not specified, the test case(s) will be executed on the I-stream on which the command is entered.

HOTS

specifies that the HOTS driver is to be run.

HS64

specifies that the 64 bit version of HOTS driver is to be run.

FIleadd

uses the address specified as the address of the ‘hot record’.

FAcid

uses the FACE ID specified as the FACE ID of the ‘hot record’.

Normal

specifies NO SNIPPETS run.

SNippets

specifies ALL SNIPPETS run.

NOSNippets

specifies run ONE SNIPPET runs.

STate

specifies the state of the VFA buffer, VFA-X lock, delay file pending etc. If not specified, the default state is one.

SErvice

specifies which FIND and FILE macros to use in the test. If not specified, the default service is one.

Ordinal

specifies a number in Hex 0x00-0x13. If not specified, the default is ordinal 0.

© Copyright IBM Corp. 2006 HOTX Driver User's Guide 5