IBM ETX-DB-ATX specifications Etx-Db-Atx, ETX MODULE BASEBOARD PCB Manual Revision, Introduction

Page 1
ETX-DB-ATX

ETX-DB-ATX

ETX MODULE BASEBOARD

PCB V1.2

Manual Revision 1.0

April 11, 2002

Copyright 2003 by ICP Electronics Inc. All Rights Reserved.

The information in this document is subject to change without prior notice in order to improve reliability, design and function and does not represent a commitment on the part of the manufacturer.

In no event will the manufacturer be liable for direct, indirect, special, incidental, or consequential damages arising out of the use or inability to use the product or documentation, even if advised of the possibility of such damages.

This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic, or other means in any form without prior written permission of the manufacturer.

Trademarks

ETX-DB-ATX is a registered trademark of ICP Electronics Inc. IBM PC is a registered trademark of International Business Machines Corporation. Intel is a registered trademark of Intel Corporation. Other product names mentioned herein are used for identification purposes only and may be trademarks and/or registered trademarks of their respective companies

 

Contents

 

1. Introduction

4

1.1

Specifications

4

1.2 What You Have

5

2. Installation

6

2.1 ETX-DB-ATX Board Layout

6

2.2

Unpacking Precautions

8

2.3

LCD Vcc Voltage Selector

8

2.4 Clear CMOS Setup

8

2.5

WatchDog Timeout Active Selector

9

2.6

Internal Buzzer Enable/Disable

9

2.7

Ethernet Controller Setting

9

3. Connection

10

3.1 ETX Connector X1

10

3.2 ETX Connector X2

11

3.3 ETX Connector X3

12

3.4 ETX Connector X4

13

3.5

Floppy Disk Drive Connector

14

3.6

PCI E-IDE Disk Drive Connector

15

3.7

Parallel Port

16

3.8

Serial Ports

16

3.9

USB Port Connector

17

3.10 IrDA Infrared Interface Port

18

3.11 TV-OUT Interface Port

18

3.12 VGA Connector

18

3.13 LCD/LVDS Interface Connector

19

3.14 LAN RJ45 Connector

19

3.15 AUDIO JACK

20

ETX-DB-ATX 2

Image 1
Contents ETX-DB-ATX 2. InstallationETX-DB-ATX ETX MODULE BASEBOARD PCB Manual Revision3ETX-DB-ATX 1.1 Specifications Display interface1 Introduction 1.2 What You Have 2 Installation2.1 ETX-DB-ATX Board Layout 2.4 Clear CMOS Setup 2.2 Unpacking PrecautionsClear CMOS Setup 7ETX-DB-ATX3.1 ETX Connector 2.5 WatchDog Timeout Active Selector2.6 Internal Buzzer Enable/Disable 2.7 Ethernet Controller Setting3.2 ETX Connector X2 X2 ISA Bus 3.3 ETX ConnectorX3 VGA, LCD, Video, COM1, COM2, LPT/Floppy, Irda, Mouse, and Keyboard 3.5 Floppy Disk Drive Connector 3.4 ETX ConnectorCN4 FDC CONNECTOR X4 IDE1, IDE2, and Miscellaneous15ETX-DB-ATX 3.6 PCI E-IDE Disk Drive Connector3.7 Parallel Port 3.8 Serial Ports3.12 VGA Connector 3.9 USB Port Connector3.10 IrDA Infrared Interface Port CN12 Two channel 48 bits LVDS Interface Connector 3.13 LCD/LVDS Interface Connector3.14 LAN RJ45 Connector 19ETX-DB-ATXPSLOT1~PSLOT2 PCI Bus pin assignment 21ETX-DB-ATX3.17 ISA BUS Interface ISA1 ISA Bus pin assignment3.20 Digital IO connector CN1 Digital IO connector pin assignment 3.18 ATX power connector PW1 ATX power connector pin assignment3.21 Keyboard & PS/2 Mouse Connector 23ETX-DB-ATX