Chapter 2 Initial Switch Configuration
Verifying the Module Status
Se n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a ck - d o c @ c i s c o . c o m
Verifying the Module Status
Before you proceed with further configuration of the switch, ensure that the modules in the chassis are functioning as designed. To verify the status of a module at any time, issue the show module command. All the hardware that was physically installed should be displayed.
A sample output of the show module command follows:
switch# show module |
|
|
Mod Ports | Model | Status |
---
2 | 32 | 1/2 Gbps | FC Module | ok | |
3 | 16 | 1/2 Gbps | FC Module | ok | |
4 | 8 | IP Storage Services Module | ok | ||
5 | 0 | active * | |||
6 | 0 | ||||
7 | 0 | Caching Services Module | ok | ||
9 | 32 | Advanced | Services Module | ok | |
Mod | Sw | Hw | (WWN) |
| |
---
2 | 2.1(1a) | 1.1 | 20:41:00:05:30:00:86:9e to 20:60:00:05:30:00:86:9e |
3 | 2.1(1a) | 3.0 | 20:81:00:05:30:00:86:9e to 20:90:00:05:30:00:86:9e |
4 | 2.1(1a) | 4.0 | 20:c1:00:05:30:00:86:9e to 20:c8:00:05:30:00:86:9e |
5 | 2.1(1a) | 4.0 | |
6 | 2.1(1a) | 4.0 | |
7 | 2.1(1a) | 0.702 | |
9 | 2.1(1a) | 0.502 | 22:01:00:05:30:00:86:9e to 22:20:00:05:30:00:86:9e |
Mod | Application Image Description | Application Image Version |
7 | 1.3(5m) | |
7 | 1.3(5m) | |
9 | SSI linecard image | 2.1(1) |
Mod | ||
---
2
3
4
5
6
7
9
* this terminal session
Note If you do not see all the installed hardware, contact your storage vendor support organization for further assistance.
Cisco MDS 9000 Family Fabric Manager Quick Configuration Guide
|
| ||
|
|