Cisco Systems 4000 specifications WS-X4448-GB-LX, CSCee05078

Chapter 1 Module Overview and Specifications

Gigabit Ethernet Switching Modules

WS-X4448-GB-LX

The WS-X4448-GB-LX 48-port Gigabit Ethernet switching module (see

Figure 1-33) has the following specifications:

Specification	Description
Module type	1000BASE-X Gigabit Ethernet switching module
Port duplex mode	Full duplex mode
Port speed	1000 Mbps
Number of ports	48
Connector type	LC type (See Figure 2-9 on page 2-6.)
Cable type	MMF or SMF (LX fiber-optic cable only)

Figure 1-33 WS-X4448-GB-LX 48-Port Gigabit Ethernet Switching Module

WS-4448-GB-LX

STATUS

1	3	5	7	9	11		13	15	17	19
											21	23	25	27	29
																31	33	35	37	39	41	43
2	4	6																						45	47
			8	10	12		14	16	18	20
											22	24	26	28	30
																32	34	36	38	40	42	44
																								46	48
2	4
		6	8		10
						12	14	16	18	20	22
												24	26	28
															30	32	34
																		36	38	40	42	44
																							46	48

55780

Ports on this switching module may be oversubscribed, depending on utilization. For further information on these ports, see the “Configuring Gigabit Ethernet Ports” section on page 3-9.

The 48 ports can be configured with any combination of small, form-factor pluggable (SFP) modules. For a description of SFP modules, see the “Installing SFP Modules” section on page 2-22.

Problem Insertion of unsupported SFPs (small form-factor pluggable optics) into

aWS-X4448-GB-LX module can cause undetected communication failures between the supervisor engine and the corresponding module. Subsequent insertion or removal of SFPs from the module is not recognized by the system. This activity can be observed on a Catalyst 4500 series switch using Release 12.1(12c)EW1 or later releases.

	Solution	Reset the module with the hw-module module reset command.
	(CSCee05078)
	Catalyst 4500 Series Module Installation Guide
1-36		78-13267-06