Cisco Systems 3750 manual Igmpquerier Messages, This section contains the Igmp querier messages

Page 79

Chapter 3 Message and Recovery Procedures

IGMP_QUERIER Messages

Error Message IDBMAN-4-ACTIVEPORTSINAGGPORT: [chars]( [dec] / [dec] ) has [dec] active ports, but is being removed.

Note This message applies only to Catalyst 3750, 3560, 2975, 2970, and 2960 switches.

Explanation An internal error removed an aggregate port that has active ports. [chars] is the port-channel name, and the ([dec] / [dec]) are the slot and port number (slot/port). The last [dec] is the number of currently active ports.

Recommended Action Copy the message exactly as it appears on the console or in the system log. Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to look for similar reported problems. If you still require assistance, open a case with the TAC, or contact your Cisco technical support representative, and provide the representative with the gathered information. For more information about these online tools and about contacting Cisco, see the “Error Message Traceback Reports” section on page 2-7.

IGMP_QUERIER Messages

This section contains the IGMP querier messages.

Error Message IGMP_QUERIER-4-NO_IP_ADDR_CFG: The IGMP querier cannot send out General Query messages in VLAN [dec] because there is no IP address configured on the system.

Note This message applies only to Catalyst 3750, 3560, 2975, 2970, and 2960 switches.

Explanation You must specify an IP address for the IGMP querier at either the global or per-VLAN level. [dec] is the VLAN ID.

Recommended Action Configure a source IP address for the IGMP querier.

Error Message IGMP_QUERIER-4-PIM_ENABLED: The IGMP querier is operationally disabled in VLAN [dec] because PIM has been enabled on the SVI.

Note This message applies only to Catalyst 3750 and 3560 switches.

Explanation PIM was detected on the SVI. Do not enable the IGMP querier when PIM is enabled on the SVI. [dec] is the VLAN ID.

Recommended Action Ensure that PIM is disabled on the SVI.

Catalyst 3750, 3560, 3550, 2975, 2970, and 2960 Switch System Message Guide

 

OL-8551-04

3-61

 

 

 

Image 79
Contents Americas Headquarters Page Iii N T E N T SNetworkportsatellite Messages PM Messages OL-8551-04 Vii AudiencePurpose ConventionsViii Related PublicationsDevice manager online help available on the switch See these documents for other information about the switchOL-8551-04 System Message Overview How to Read System MessagesBoot loader patch Automatic quality of serviceAuto-QoS only Catalyst Switches 2975 switchesGigaStack Gbic module Catalyst 3550 switch onlyPower over Ethernet PoE Protocol only Catalyst 3750 SwitchesFacility Code Description Location QoS trusted boundary Ternary content addressable memoryWrlscntr Messages Catalyst 3750 Integrated Wireless LAN Mac address table manager onlyType of Information Output Interpreter Error Message Traceback ReportsOL-8551-04 Autoqos Messages, page 3-8only Catalyst 3550 switches Message and Recovery ProceduresIpdevicetrackingha Messages, PBR Messages, page 3-75only Catalyst 3550 switchesAclmgr Messages SDM Messages, page 3-118only Catalyst 3750 and 2975 switchesMessage and Recovery Procedures Aclmgr Messages Message and Recovery Procedures Aclmgr Messages Message and Recovery Procedures Aclmgr Messages Message and Recovery Procedures Aclmgr Messages Autoqos Messages Backupinterface MessagesThis section contains the Flex Link messages This section contains the Badtransceiver message This section contains the boot loader patch messagesBadtransceiver Messages Bspatch MessagesCfgmgr Messages This section contains the configuration manager messagesMessage and Recovery Procedures Cfgmgr Messages Error Message CFGMGR-6-APPLYINGRUNNINGCFG as new master CMP Messages Dhcpsnooping Messages Message and Recovery Procedures Dhcpsnooping Messages Message and Recovery Procedures Dhcpsnooping Messages DHCPSNOOPINGCAT3550 Messages DOT1X Messages DOT1QTUNNELLING MessagesThis section contains the Ieee 802.1x messages Recommended Action Reload the device DOT1XSWITCH MessagesMessage and Recovery Procedures DOT1XSWITCH Messages Message and Recovery Procedures DOT1XSWITCH Messages Message and Recovery Procedures DOT1XSWITCH Messages DTP Messages DWL Messages EC Messages Message and Recovery Procedures EC Messages Message and Recovery Procedures EC Messages Error Message EC-5-NOLACP Invalid EC mode, Lacp not enabled This section contains the Environment messages Environment MessagesEthcntr Messages Error Message ETHCNTR-3-INTERNALERROR Internal Error chars Message and Recovery Procedures Ethcntr Messages Message and Recovery Procedures Ethcntr Messages This section contains messages for the Express Setup feature Expresssetup MessagesFM Messages Error Message FM-3-CONFLICT chars chars conflicts with chars Error Message FM-3-GOTVLABEL Got label for Vlan dec Message and Recovery Procedures FM Messages Message and Recovery Procedures FM Messages Message and Recovery Procedures FM Messages Message and Recovery Procedures FM Messages Tcam ID Message and Recovery Procedures FM Messages This section contains the front-end controller messages Frntendctrlr MessagesGbic Messages Message and Recovery Procedures Gbic Messages Message and Recovery Procedures Gbic Messages Gbicsecurity Messages Message and Recovery Procedures Gbicsecurity Messages Message and Recovery Procedures Gbicsecurity Messages Gbicsecuritycrypt Messages Gbicsecurityunique Messages This section contains the GigaStack Gbic module messages Gigastack MessagesThis section contains hardware messages Hardware MessagesMessage and Recovery Procedures Hardware Messages Hlfm Messages This section contains port-security messages Hpsecure MessagesIdbman Messages Message and Recovery Procedures Idbman Messages Message and Recovery Procedures Idbman Messages This section contains the Igmp querier messages Igmpquerier MessagesThis section contains the Power over Ethernet PoE messages Ilpower MessagesMessage and Recovery Procedures Ilpower Messages Message and Recovery Procedures Ilpower Messages Message and Recovery Procedures Ilpower Messages Message and Recovery Procedures Ilpower Messages Message and Recovery Procedures Ilpower Messages Message and Recovery Procedures Ilpower Messages Imagemgr Messages Error Message IMAGEMGR-6-AUTOCOPYSW charsIpdevicetrackingha Messages L3TCAM Messages L2TM MessagesMaclimit Messages Networkportsatellite Messages Macmove MessagesThis section contains the Macmove messages Pagpdualactive Messages This section contains the policy-based routing PBR messages PBR MessagesMessage and Recovery Procedures PBR Messages This section contains the PHY messages PHY MessagesMessage and Recovery Procedures PHY Messages Pimsn Messages This section contains low-level platform-specific messages Platform MessagesPlatformfbm Messages This section has the Cisco Express Forwarding CEF message Platformhcef MessagesThis section has the platform pseudo label manager messages Platformhplm MessagesPlatform IPC Messages This section contains the IP Version 6 message PLATFORMIPv6 MessageThis section contains policy based routing PBR messages Platformpbr MessagesMessage and Recovery Procedures Platformpbr Messages This section contains platform port manager PM messages Platformpm MessagesPlatformrpc Messages Message and Recovery Procedures Platformrpc Messages Platformspan Messages This section contains platform unicast routing messages Platformucast MessagesError Message PLATFORMUCAST-3-CEF chars Error Message PLATFORMUCAST-3-HSRP chars This section contains platform Vlan messages Platformvlan MessagesPlatformwccp Messages PM Messages Message and Recovery Procedures PM Messages Error Message PM-4-BADCOOKIE chars was detected 100 101 102 103 104 This section contains the port security messages Portsecurity Messages105 106 107 Qatm Messages108 QM Messages109 110 111 Qosmgr Messages112 113 114 115 116 117 Rmon MessagesSpan Messages SDM Messages118 This section contains the spanning-tree messages Spantree Messages119 120 121 122 123 124 125 126 Vlan ID127 Spantreefast MessagesSpantreevlansw Messages Stackmgr Messages128 129 This section contains the storm control messages Stormcontrol Messages130 Supq Messages Supervisor Messages131 132 133 Swdai Messages134 135 136 Swmacauth MessagesSwvlan Messages Swmatm Messages137 138 139 140 141 142 143 144 145 Switchqostb MessagesTcammgr Messages This section contains the QoS trusted boundary TB messages146 147 Udld Messages148 149 Ufastmcastsw Messages150 Vqpclient MessagesWrlscntr Messages Wccp Messages151 152 Document conventions Documentation, relatedIN-1 IN-2 IN-3 IN-4 IN-5 Power over Ethernet messagesPlatformipc messages Platformpbr messages Publications, relatedIN-6
Related manuals
Manual 15 pages 53.18 Kb

3750 specifications

The Cisco Systems 3750 series is a family of enterprise-class stackable switches that were designed to provide high-performance networking solutions for organizations requiring robust management features, security, and scalability. Known for their reliability and advanced capabilities, the 3750 series is particularly aimed at accommodating the demands of LAN environments in organizations ranging from small businesses to large enterprises.

One of the defining features of the Cisco 3750 series is its StackWise technology. This innovative feature enables the stacking of up to nine switches together, allowing them to function as a single logical unit. This results in simplified management, higher redundancy, and increased scalability. The StackWise technology allows for seamless failover and enhanced bandwidth between the stacked switches.

In terms of performance, the 3750 series supports Layer 2 and Layer 3 switching, offering routing capabilities to handle both traditional and modern network demands. It is equipped with advanced Quality of Service (QoS) features, ensuring that critical applications such as voice and video are prioritized for optimal performance.

The Cisco 3750 also features extensive security capabilities. It incorporates features such as IEEE 802.1X authentication, DHCP snooping, and dynamic ARP inspection to protect against unauthorized access and various network attacks. These enhancements help maintain data integrity and secure communications across the network.

Another noteworthy characteristic of the 3750 series is its support for Power over Ethernet (PoE). PoE allows for the delivery of power over Ethernet cables to connected devices, such as IP phones and wireless access points, facilitating simpler installations and reducing the need for additional power outlets.

The Cisco 3750 series also provides a comprehensive set of management tools. With features like Cisco's Embedded Event Manager (EEM) and extensive SNMP support, network administrators can efficiently monitor and manage network performance, troubleshoot issues, and maintain high availability.

Additionally, the series is compatible with Cisco's IOS software, which provides a rich set of features, including advanced routing protocols, multicast support, and extensive security options, further enhancing the functionality and versatility of the switches.

Overall, the Cisco Systems 3750 series stands out for its stackable design, high-performance features, security capabilities, and management tools, making it a popular choice for organizations looking for dependable and scalable networking solutions.