Chapter 3 Installing the Driver, Client Utility, and Client Adapter
Installing the Driver and Client Utility
Figure 3-2 Mac OS X Install Screen
Step 7 When the Cisco WLAN Install screen appears, perform the following operations:
a.Expand the Mac OS software component list by clicking the right triangle on the left of the Mac OS name.
Note Both the PCI and PC Card drivers are normally installed by the installer. You can deselect one of the drivers by clicking the selection box to remove the X; for example: you can deselect the PCI driver when using a PowerBook or you can deselect the PC Card driver when using a PowerMac.
b.Click Install to begin the installation process.
Step 8 Click Continue when a screen appears indicating your computer must restart after installing the software.
Note You can click Cancel to terminate the install process.
Step 9 A message appears indicating “One moment please...” then a screen appears that shows the installation progress. After the files are copied to the Macintosh hard disk, a window appears indicating that the installation was successful. Perform one of the following steps:
a.Click Restart to restart your computer and finish the client utility installation.
b.Click Continue if you need to perform additional installations.
c.Click Quit to leave the installer program and return to your computer desktop screen. You must manually restart your computer at a later time to finish the client utility installation and to manually configure the client adapter using the client utility.
The client utility, the help files, and the drivers have been installed by the installer program.
Note When your Mac OS 9.x computer restarts, a
For Mac OS 9.x, follow the instructions in the “Inserting the Client Adapter into a Computing Device” section on page
Cisco Aironet Wireless LAN Client Adapters Installation and Configuration Guide for Mac OS
| ||
|