Cisco Systems 3545 PRI, 3545 Serial manual Serial Gateway Cable Connections and Pin-outs

Chapter 2 Installing the Cisco Unified Videoconferencing 3545 Gateway

Serial Gateway Cable Connections and Pin-outs

Procedure

Step 1 Connect the DB-60 male connector of the cable to the DB-60 female connector of the unit. Step 2 Tighten the screws.

Step 3 Connect the remote connectors (V.35, RS-449, EIA-530 and RS-366) to the connectors or the connecting cable of the remote equipment

Serial Gateway Cable Connections and Pin-outs

•Physical Description of DTE Cables, page 2-16

•Physical Description of DCE Cables, page 2-20

•Data Interface Cable Pin-out Configurations, page 2-22

•Data Interface Pin Layouts, page 2-23

•Signaling Interface Cable Pin-out Configuration, page 2-25

•Signaling Interface Pin Layout, page 2-26

Physical Description of DTE Cables

	These are the DTE cables supplied with the Cisco Unified Videoconferencing 3545 Serial Gateway:
	•	V.35/RS366-DTE, page 2-17
	•	EIA449/RS366-DTE, page 2-17
	•	EIA530/RS366-DTE, page 2-18
	•	EIA530/RS366-DTE-LOS, page 2-18
	•	EIA530A/RS366-DTE, page 2-19
	•	KIV7/RS366-DTE, page 2-19
Note	•	The DB-25connector provides the data interface for the “EIA530/RS366-DTE”and
		“EIA530/RS366-DTE-LOS” cables.

• The DB-37connector provides the data interface for the “EIA449/RS366-DTE”and “KIV7/RS366-DTE”cables.

• The DB-25connector provides the RS-366 signaling interface for all Cisco Unified Videoconferencing 3545 Serial Gateway cables.

	Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 PRI Gateway and 3545 Serial Gateway Release 5.6
2-16	OL-17011-01