Cisco Systems 1040 manual Selecting and Configuring a Cisco Catalyst Switch

Table 1	Cisco 1040 Port Usage (continued)
Protocol	Port Number	Service Name
UDP	69	TFTP—Cisco 1040 uses TFTP to get a configuration file and
		binary image file.
UDP	514	Syslog—Cisco 1040 sends syslog messages to Service Monitor.
TCP	2000	SCCP—Cisco 1040 uses SCCP to communicate with Service
		Monitor.
TCP	80	http—Cisco 1040 has a web-based user interface to view its
		configuration

Selecting and Configuring a Cisco Catalyst Switch

Note Cisco 1040 should be installed on the Cisco switch nearest the IP telephones that are being monitored.

To connect the Cisco 1040, you need a Cisco Catalyst switch with the following:

•A port that supports IEEE 802.3af standard Power over Ethernet (PoE).

Note To use inline power on a Cisco Catalyst 3550, you must configure the port from the

command line using this Cisco IOS command:

power inline delay shutdown 20 initial 30

For more information on Cisco Catalyst command reference guides, see Related Documentation, page 12.

•A port that is configured as a SPAN or RSPAN destination port for:

–Ports to which phones are connected

–VLANs

For information about configuring SPAN and RSPAN on Cisco Catalyst switches and modules, see the following URL.

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a008015c61 2.shtml.

6