Connecting to an Electrical Power Source
Note There are advanced setup options of the encoder that you will need to modify before running an encoder session. You will use the Niagara SCX® Web Interface to access these options. Refer to the User Guide for Cisco Digital Media Encoder 1100 for detailed instructions.
Connecting to an Electrical Power Source
Figure 2 shows the rear panel of the encoder.
Figure 2 | Rear Panel |
190000
Using the reference chart and images in Table 1, you can connect the appropriate device and power to the encoder.
Table 1 | Rear Panel Power Connections | |
|
|
|
Connection |
| Description |
|
| |
AC Power connector for | Plug the power cable that was include with your encoder to | |
volts, AC, | this connector and plug the opposite end into an AC power | |
|
| source or electrical wall outlet. |
|
|
|
Quick Start Guide for Cisco Digital Media Encoder 1100
2 |
| |
|