Cisco Systems Cisco 7513-MX, CISCO7576 manual Bottom ejector lever Processor module slot Module

Page 10

Removing and Replacing Processor Modules

Figure 5

Ejector Levers and Captive Installation Screws

a

Bottom ejector lever

Processor module slot

Processor

module

carrier guide

Captive

installation

screw

b

Stop

immediately

on contact

c

H1482a

10Cisco 7513, Cisco 7513-MX, and Cisco 7576 Card Cage and Backplane Assembly Replacement Instructions

Image 10

Contents Document Contents Product Overview Cisco 7513, Cisco 7513-MX, and Cisco 7576-Rear-Panel View Cisco 7513 and Cisco 7513-MX Backplane Installation Safety, ESD Precautions, and Tools Required Safety Warnings Safety Guidelines Safety with ElectricityTools Required Preventing Electrostatic Discharge DamageRemoving and Replacing Processor Modules Removing Processor ModulesBottom ejector lever Processor module slot Module Replacing Processor Modules Board Rack with Processor ModulesRemoving Power Supplies Handling a Processor Module During InstallationRemoving a Power Supply AC-Input Power Supplies Shown Removing the Old Card Cage and Backplane Assembly Power Supply BlankRemoving the Old Card Cage and Backplane Assembly Removing the Card Cage and Backplane Assembly Exchanging the Eeprom DevicesPin Installing the New Card Cage and Backplane Assembly Replacing the Card Cage and Backplane Assembly Replacing Power Supplies Replacing a Power Supply AC-Input Power Supplies ShownChecking the System Following is an example of this display Port and Slot Conﬁguration Worksheet Router Names Location Serial NumberCisco 7513 and Cisco 7513-MX Slot Assignments Cisco 7576 Slot AssignmentsCisco Connection Online Documentation CD-ROMDocumentation CD-ROM