Installation Instructions
Installation Instructions
The following sections contain procedures for installing the antenna on a suspended ceiling.
Mounting on Suspended Ceilings with Flush Mounted Tiles
The antenna is configured to mount to a suspended ceiling track with flush mounted tiles. Suspended ceiling mounting clips are provided on the rear panel of the antenna. (See Figure 7.)
Figure 7 | Suspended Ceiling with Flush Mounted Tiles | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Side view
Top view
1 | 127077 |
| |
| 2 |
1
Ceiling track
2
Suspended ceiling mounting clips
After you have selected a suitable location, follow these steps to mount the antenna:
Step 1 Make two small slots in the ceiling tile for the cables to pass through.
Step 2 Line up the antenna mounting clips with the ceiling track.
Step 3 Grasp the antenna with one hand and the track with the other while gently pushing the antenna until the clips are securely attached to the track.
Step 4 Route the antenna cables into the space above the ceiling grid and connect them to the device or extender cables.
Step 5 Replace the ceiling tiles.
Note You may have to trim some material from one of the tiles to accommodate the antenna cables.
Cisco Multiband Diversity Omnidirectional
10 |
| |
|