Chapter 3 Configurations for the Layer 3 Switch Router
Updating the System Image
Source filename
Destination filename
Accessing
Erase bootflash: before copying? [confirm] no
Loading
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!
!
[OK - 3173364/6345728 bytes]
Verifying checksum... OK (0x755F)
3173364 bytes copied in 210.364 secs (15111 bytes/sec) Router# dir bootflash:
Directory of bootflash:/
1 | 3173128 | <no | date> | ||
2 | 3173364 | <no | date> |
16777216 bytes total (10430596 bytes free)
Note Make sure that the file size of the image file you copied to bootflash memory matches the image file size on the server.
Reloading the Layer 3 Switch Router
When the configuration register is set for manual booting, entering the reload command causes the system to enter ROM monitor mode, where you enter the boot command and the name of the system image to use. To perform this procedure, you must be connected to the console port, which provides access to the Layer 3 switch router when in ROM monitor mode. For automatic booting, you can enter the reload command from an Ethernet connection to the route processor.
| Note | This procedure assumes that you need to change the boot field in the configuration register from its | ||||||
|
| default value so that the system reverts to ROM monitor mode when you enter the reload command. | ||||||
|
|
|
|
|
| |||
|
| To reload the Layer 3 switch router with the new system image in bootflash memory, perform the | ||||||
|
| following procedure, beginning in global configuration mode: | ||||||
|
|
|
|
| ||||
|
| Command | Purpose | |||||
| Step 1 |
|
|
| ||||
| Router(config)# | Set the configuration register for manual booting from ROM | ||||||
|
|
| monitor mode. 1 | |||||
| Step 2 |
|
|
| ||||
| Router(config)# end | Return to privileged EXEC mode. | ||||||
|
| Router# |
|
|
|
|
|
|
| Step 3 |
|
|
| ||||
| Router# copy | Save your configuration changes to NVRAM. | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Catalyst |
|
|
|
|
| |
|
|
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
| ||||