Cisco Systems AM10 manual Appendix D Regulatory Information, FCC Statement, Safety Notices

Page 14

Appendix D: Regulatory Information

Appendix D: Regulatory Information

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:

•• Reorient or relocate the receiving antenna.

•• Increase the separation between the equipment and receiver.

•• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

•• Consult the dealer or an experienced radio/TV technician for help.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

The availability of some specific channels and/or operational frequency bands are country dependent and are firmware programmed at the factory to match the intended destination. The firmware setting is not accessible by the end user.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End users mustfollowthespecificoperatinginstructionsforsatisfying RF exposure compliance. To maintain compliance with FCC RF exposure compliance requirements, please follow operation instructions as documented in this manual.

This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

SAR compliance has been established in typical laptop computer(s) with USB slot, and this product could be used in typical laptop computer(s) with USB slot. Other applications like handheld PC or similar device have not been verified and may not be in compliance with related RF exposure rule and such use shall be prohibited.

Safety Notices

WARNING: Do not use this product near water, for example, in a wet basement or near a swimming pool.

WARNING: Avoid using this product during an electrical storm. There may be a remote risk of electric shock from lightning.

WARNING: This product contains lead, known to the State of California to cause cancer, and birth defects or other reproductive harm. Wash hands after handling.

WARNING: For use with a Listed Computer.

12

Image 14
Contents User guide Contents USB Extension Base Product OverviewStoring the Cap Installation InstallationClick Next. Go to step If your network does not use wireless security, go to step Wireless Network ConfigurationNew Wireless Connection WindowsWindows Vista Click Connect to a networkWireless Network Configuration This screen appears while the Valet ConnectorWindows XP Appendix a Troubleshooting Make sure that the computers are powered onSecurity Key Bits Up to 128-Bit Encryption Appendix B SpecificationsNo. of Antennas Internal Antennas Connector Type Storage Humidity To 90% NoncondensingExclusions and Limitations Appendix C Warranty InformationLimited Warranty A, Canada, Asia Pacific, Australia, New ZealandObtaining Warranty Service Technical SupportFCC Statement Safety NoticesAppendix D Regulatory Information FCC Radiation Exposure StatementRèglement d’Industry Canada Wireless DisclaimerIndustry Canada Statement Appendix D Regulatory Information Software Licenses Appendix E Software End User License AgreementCisco Products Schedule 1 Cisco Software License AgreementAppendix E Software End User License Agreement Appendix E Software End User License Agreement END of Schedule Schedule 2 Open Source and Third Party Licenses Version 2, JuneAppendix E Software End User License Agreement END of Terms and Conditions END of Schedule 2-A Schedule 2-B Version 2.1, FebruaryAppendix E Software End User License Agreement Appendix E Software End User License Agreement Appendix E Software End User License Agreement END of Terms and Conditions END of Schedule 2-B Openssl License END of Schedule 2-C