Installation
Installing the Cisco 4400 Series Power Supply
Figure 1 | Controller Slots |
Slot 1
Slot 2
142297
Step 2 Using the Phillips screwdriver, remove the cover from the desired power supply slot by unscrewing the captive screws and removing it. Store the power supply slot cover for later use.
Step 3 Insert the power supply into the slot. Make sure that the power supply input receptacle is on the left side of the slot as shown in Figure 2.
Figure 2 | Inserting the Power Supply |
Step 4 Gently but firmly press the power supply into the slot until it is firmly seated in the card electrical connector. Use the provided captive screws to secure the power supply to the Cisco Wireless LAN Controller.
Quick Start Guide: Power Supplies for Cisco 4400 Series WLAN Controllers
2 |
| |
|