10/100 16-Port

A Division of Cisco Systems, Inc.

1 Connect the Router

Configure the Router

Package Contents

• 10/100 16-Port VPN Router

• User Guide CD-ROM

• AC Power Cable

• Rack Mounting Kit

• Quick Installation

• Registration Card

		VPN Router
	WIRED	Quick Installation
Model No. RV016

	A Before you begin, make sure
	that all of your hardware is
	powered off, including the
	Router, PCs, hubs, switches,
	and cable or DSL modem.
	B Connect one end of an Ether-
	net network cable to one of
	the numbered ports on the
	front of the Router (see Figure
	B). Connect the other end to
	an Ethernet port on a network
	device, e.g., a PC, print server,
	hub, or switch.	B
	Repeat this step to connect	B
	Repeat this step to connect
	more PCs or other network
	devices to the Router.
	C Connect your cable or DSL
	modem’s Ethernet cable to
	the Router’s Internet port. If
	using multiple Internet ports,
	connect a cable to each Inter-
	net port you’d like to use, and
	connect the other end to your	C
	modem. See Figure C.	C
	modem. See Figure C.
	D Power on the cable or DSL
	modem and the other network
	device if using one.

E Connect the included AC power cable to the Router’s Power port on the back of the Router, as shown in Figure E, and then plug the other end of the power cable into an elec- trical outlet.

The System LED on the front panel will light up as soon as the power adapter is con- nected properly.

Configuring the Router requires the setup instructions provided by your Internet Service Provider (ISP). If you do not have this information, con- tact your ISP before proceeding.

Your ISP determines how your PC is set up for Internet access. Because you are now using the Router to share Internet access among sev- eral computers, you will use the setup information to configure the Router instead of your PC.

A Open your PC’s web browser. Enter http://192.168.1.1 (the Router’s default local IP address) in the web browser’s Address field and press the Enter key.

B Enter a User Name and Pass- word on the screen that appears. Enter admin (the default) in the the User Name and Password fields. Then, click the OK button.

C The Router’s Web-based Utility will appear with the System Summary screen showing. Click on the Setup tab, which is the next tab over, then con- tinue with the instruction, below, to complete the Net- work page.

NOTE:: Make sure your PC’s Ethernet adapter is set to obtain an IP address automatically. For more information, refer to Win- dows Help.