Cisco Systems OL-6563-01 manual Layer 2 Configuration, Layer 3 Configuration

Page 4

Chapter 5 Network Element Management

Chassis Layer2/Layer3 Management Window

Layer 2 Configuration

The Layer 2 Configuration area provides the following information:

CDP—Displays the Cisco Discovery Protocol (CDP) global status on the network element, enabled or disabled.

UDLP—Displays the UniDirectional Link Detection Protocol (UDLP) global status on the network element: enabled, aggressive, or disabled. The “aggressive” option is not applicable for CatOS.

802.1x—Displays the 802.1x Port Based Authentication global status on the network element, enabled or disabled.

Note Dot1x cannot be enabled if dynamic mode is enabled on one or more ports.

Layer 3 Configuration

The Layer 3 Configuration area provides the following information:

IP CEF—Displays the status of the IP CEF routing on the network element, enabled or disabled. This feature cannot be disabled on Cisco 3950, 4000, 4500, 6000, 6500, and 7600 series devices.

IP Multicast—Displays the status of the IP Multicast routing on the network element, enabled or disabled.

 

Cisco 7600 Router Manager User Guide

5-4

OL-6563-01

Image 4
Contents Network Element Management Chassis Layer2/Layer3 Management Window Chassis Layer2/Layer3 Management Window Layer 2 Configuration Layer 3 ConfigurationNetwork Element Management Window Configuration Tab System Information Tab Snmp Access Tab Configuration Tab SystemIP Address Operating SystemIOS Session Cat OS SessionReset System System Information Tab Snmp Access TabActions IOS Snmp Cat OS SnmpTrap Generation Snmp Trap TabSnmp Trap Chassis Management-Configure Snmp Trap Client Window Device Management Tab Additional Notes TabMAC Address Query Window MAC Address Query Window Network Element MAC Address QueryNetwork Element Management