Related Documentation
Changes
The following command has been added to the CLI:
•To enable the sending of LUN Change Async events for the specified SCSI routing instance and target combination, use the scsirouter target lunasyncevent enable command. To disable this function at the target level, use the no form of this command.
scsirouter name target name lunasyncevent enable
By default, the sending of LUN async events is disabled for all SCSI routing instances and targets. You can enable this function for SCSI routing instances at the target level only. See caveat CSCee00457 for complete details.
Related Documentation
The following sections describe the related documentation available for Cisco SN 5428 Storage Router release 3.5.3. These documents consist of hardware installation and software configuration guides, and
Release-Specific Documents
This release notes document is the only document specific to SN 5428 release 3.5.3. It is only available as an electronic document on Cisco.com and the Documentation
Hardware Documents
Refer to the Cisco SN 5428 Storage Router Hardware Installation Guide for hardware installation procedures. This document is available as an electronic document on Cisco.com and the Documentation
Software Documents
Refer to the Cisco SN 5428 Storage Router Software Configuration Guide Release 3.4, for configuration information and procedures. This document is available as an electronic document on Cisco.com and the Documentation
Refer to the Cisco SN 5400 Series Storage Router Command Reference, Release 3.5, for information about the CLI command interface. This document is available as an electronic document on Cisco.com and the Documentation
For documentation on the SN 5428
Release Notes for Cisco SN 5428 Storage Router Release 3.5.3
| 11 |
| |
|
|