Quick Start Guide
Hardware Overview
The Front LEDs
Lit orange red when power is ON. Lit red means system is fail. Lit green when the system is ready.
Lit green when the USB device is ready. Flash when data is being transmitted / received.
Lit green when SIP registration is ok for phone 1 or orange for phone 2. When registration for both phone 1 & 2 are ok, both green and orange light will lit together.
Lit Green when successfully connected to an
ADSL DSLAM, (“line sync”).
Lit when connected to an Ethernet device.
Lit Green for 1000Mbps; Orange for 100Mbps; but no light for 10Mbps. Blink when data is being Transmitted / Received.
Lit green when a wireless connection is established. Flash green when the device is sending/receiving data.
Lit green when the phone is off hook
Lit green when the inbound and outbound calls are transmitted through PSTN.
Lit red when WAN port fails to get IP address. Lit green when WAN port gets IP address successfully. Lit off when device in bridged mode or WAN connection not present.
The Rear Ports
Connect with | Connect to the |
the detachable | telephone jack on the |
antenna. | wall with |
| Press the RESET |
| |
Connect to a PC or an | button for 6 |
| |
seconds and | Connect it with the | ||
office/home network | above to restore | ||
supplied power | |||
of 10/100/1000Mbps | the factory | ||
adapter. | |||
with UTP Ethernet | default settings. | ||
| |||
cable. |
|
|
Connect to the ADSL / telephone network with
3G/ HSDPA USB modem backup for Internet access
Connect to an analog phone set with
Push to trigger | Power |
Protected Setup | ON/OFF |
function. | switch |