Chapter 3
Advanced Configuration
Status > Router
The Status > Router screen displays the Router’s current status.
Status > Router
Router Information
Firmware Version The Router’s current firmware is displayed.
Firmware Verification The verification code is displayed.
Current Time The time, which you set on the Setup tab, is displayed.
MAC Address The Router’s MAC Address, as seen by your ISP, is displayed.
Router Name The specific name for the Router, which you set on the Setup tab, is displayed.
Host Name If required by your ISP, this would have been entered on the Setup tab.
Domain Name If required by your ISP, this would have been entered on the Setup tab.
Internet
Configuration Type
This section shows the current network information stored in the Router. The information varies depending on the Internet connection type selected on the Setup > Basic Setup screen.
Click Refresh to update the
Status > Local Network
The Status > Local Network screen displays the status of your network.
Status > Local Network
Local Network
MAC Address The Router’s MAC Address, as seen on your local, Ethernet network, is displayed.
IP Address The Router’s IP Address, as it appears on your local, Ethernet network, is displayed.
Subnet Mask The current subnet mask configured for your local network is displayed.
DHCP Server If you are using the Router as a DHCP server, then the status is displayed.
Start IP Address For the range of IP Addresses used by devices on your local, Ethernet network, the beginning of that range is displayed.
End IP Address For the range of IP Addresses used by devices on your local, Ethernet network, the end of that range is displayed.
DHCP Clients Table Clicking this button will open a screen to show you which computers are using the Router as a DHCP server. You can delete computers from that list, and sever their connections; select Delete and click the Delete button.
DHCP Clients Table
Click Refresh to update the
22 |