Philips HC300 manual General information Controls, Kit contents

General information Controls

Multiple headphones with one transmitter

An additional number of headphones and/or wireless speakers can be used with a single transmitter if they:

-operate in the 433 MHz band

-can detect a 19 kHz pilot tone.

Please consult the appliance’s electrical specification sheets for confirmation on compatibility.

Kit contents

This FM headphone system consists of the following accessories:

1 x SBC HC332 FM transmitter

1 x SBC HC305 FM headphone

1 x SBC CS030/00 12Volt / 200mA AC/DC adapter (for UK: SBC CS030/05 12 Volt/ 200 mA AC/DC adapter)

2 x non-rechargeable batteries LR03/AAA (ZnCl)

1 x 3.5 mm plug to 6.3 mm stereo adapter plug

1 x antenna tube

Transmitter (figure 1)

1Power indicator – lights up when audio signals are detected at the audio input.

2DC power – connect to the 12 Volt/ 200 mA AC/DC adapter.

33.5 mm stereo headphone audio input – the audio cable connects your FM transmitter to an audio source.

4Channel switch – select one of

2 channels for best reception. We advise you to select channel 1 as a first option.

5Controls plate Headphone (figure 2)

6Power On/Off – slide the switch to the on or off position to switch the headphone on/off.

7Battery compartment – open the lid, take out the batteries and replace them when empty.

8Volume – adjust volume to your desired listening level.

9Tuning – turn the tuning wheel until the signal is at its clearest.

10Power indication – lights up when in use.

English

5